Open Search

Low-resistance fields in DC motors; application and testing

Publication date: 
September 2018
Author(s): 
Chase Fell, Precision Coil and Rotor
Type of media: 
Article

Ground faults, short circuits and bad connections in interpole coils, series coils and compensating windings cause performance problems in DC machines, including brush sparking, flashover, stalling and catastrophic failure. Shunt coils have many turns of relatively small wire and are usually excited by a DC source independent of the armature. Series, interpole and compensating coils in the armature circuit usually are wound with a few turns of heavy wire as these coils carry armature current.

For accurate test results, make sure windings are clean and dry. Verify connections of low resistance fields by visual inspection. Apply DC voltage to an assembled field frame and perform a thermography scan to detect problems including uneven heating and loose or corroded connections. Verify that the terminal lead markings are correct. Lead marking should conform to the original equipment manufacturer (OEM) nameplate, NEMA MG1 or IEC 60034-8, whichever is applicable.

Topic(s): 
DC motors
Testing
Motor testing